This simple kit is simple and fast to install.

Simply replace your current "eyeball" fittings with our valve when winterizing, drain the water lines, fill with antifreeze (highly-recommended) and prevent any water from re-entering the lines – all without draining your pool!

Installation Instructions:

Examine units (remove cap and shake to make sure parts are moving or press inner parts between fingers until parts are moving.

Use Teflon tape for threads, wrap as needed to seal threads.

Remove all eyeball units from pool lines.

Install valves without caps

Use wrench (included) no other tools required (hand tighten only - use 3/8" drive to loosen in case of over tightening)

Blow out lines (requires air compressor)

Lubricate caps with any water based lubricant (Hydra Slip Lubricant recommended) DO NOT USE OIL BASED LUBRICANT.

Snap cap on unit, press on center to fit in place, rotate cap over unit 3-4 times to optimize seal and press center.

Next Season Instructions:

Wash unit in warm soap and water to remove old lubricant.

Re-lubricate unit.

Follow insturctions 1 through 8 from above.

Special Notes:

In case of pre-existing leaks, cracks or holes in the pipelines, the use of anti-freeze is highly recommended

This product does not winterize your skimmer. See your skimmer's manufacturers instructions.